NanoVNA-F Quick Start Guide (Firmware 1.0.3)

NanoVNA-F Quick Start Guide (Firmware 1.0.3)

NanoVNA-F Quick start guide - Firmware 1.0.3 Home Menu DISPLAY TRACE MARKER FORMAT STIMULUS SCALE CALIBRATE CHANNEL RECALL RECALL 0 TRANSFORM CONFIG RECALL 1 SWEEP POINTS SAVE S1P RECALL 2 BANDWIDTH SAVE S2P RECALL 3 < BACK STORAGE By: BH5HNU Date: 20210910 Select a trace to modified the format, scale and more S11 REFLECT S21 THROUGH < BACK TRACE 0 SELECT LOGMAG TRACE 1 OFF SCALE/DIV PHASE TRACE 2 REFERENCE VALUE REFERENCE POSITION ELECTRICAL DELAY DELAY TRACE 3 SMITH < BACK SWR < BACK |Z| > MORE POLAR < BACK LINEAR TOUCH CAL RECALL 4 SELECT MARKER TOUCH TEST < BACK RECALL 5 ENGLISH RECALL 6 VERSION 繁體中文 BRIGHTNESS < BACK THRESHOLD > START Cx D R DEEPELEC.COM S T X Handheld Vector network analyzer groups.io/g/nanovna-f Facebook Group : NanoVNA-F Hangzhou Minghong Electronic Technology Co., Ltd. STOP 1500.000 000 MHz If calibration is available, the CAL status will be displayed. Otherwise, it is hidden. C * is in the state where an unsaved calibration is applied(it disappears from memory when the power is turned off). IMAG Keypad MINIUM < BACK < BACK START 10.000 kHz MAXIMUM OPERATIONS LANGUAGE 简体中文 REAL SEARCH SAVE CONFIG RESISTANCE SEARCH < LEFT SEARCH > RIGHT SMITH VALUE LIN > STOP < BACK LOG > CENTER Re+Im > SPAN TRACKING START R+Xj > EDELAY < BACK STOP R+L/C < BACK REACTANCE Q FACTOR < BACK CENTER L/C MATCH SPAN < BACK 1000HZ 51 point 333HZ 101 point 100HZ 201 point TRANSFORM ON LOW PASS IMPULSE LOW PASS STEP 30HZ 301 point BANDPASS 10HZ < BACK MARKER 1 CW FREQ MINIMUM MARKER 2 PAUSE SWEEP Keypad MARKER 3 < BACK < BACK MARKER 4 WINDOW NORMAL VELOCITY FACTOR MAXIMUM < BACK < BACK DELTA OPEN CALIBRATE POWER SAVE 0 SHORT SAVE SAVE 1 LOAD RESET SAVE 2 ISOLN APPLY SAVE 3 THRU CLEAR ALL SAVE 4 DONE < BACK SAVE 5 < BACK C0 to C4 Indicates that the saved calibration values are applied to one of the save locations. Saved or Unsaved will change when calibration data is properly saved. +1 / -8 dBm The letters below C indicate that the following error terms have been applied. D: Directivity, R: Reflection Tracking, S: Source Match, T: Transmission Tracking and X: Isolation -10 /-13 dBm Keypad < BACK SAVE 6 Deepelec Store < BACK -1 / -9 dBm -4 / -10 dBm < BACK Charge Discharge Status charging full discharging low battery Red Blink ON OFF OFF Blue OFF OFF ON Blink After turning off the power, the blue light stays on for about 40 seconds, and then goes out. 7 8 9 G 4 5 6 M 1 2 3 k 0 . ← x1 Backspace & Exit Done LIST FILES